pdf-icon

CONTENTS

ADC HAT

SKU:U069-V11

Description

ADC HAT is another type of C-HAT specifically design for M5StickC controller. Same as ADC unit, this is an ADC converter component for stickc. Packed with an ADC converter chip ADS1110, which is a fully differential, 16-bit, self-calibrating, delta-sigma A/D converter. Extremely easy to design with and configure, the ADS1110 allows you to obtain precise measurements with a minimum of effort.
The ADS1100 consists of a delta-sigma A/D converter core with adjustable gain, a clock generator, and an I2C interface.
ADS1110 itself is able to accept a differential input from -5 ~ +5 V, but we have limited the input to 0~12V by adding on the peripheral circuit design of this IC.

The main differences from the previous version of HAT-ADC are as follows:1. Input channels: The ADS1110 has single-ended and differential input channels, while the ADS1100 has only single-ended input channels.2. Reference voltage: The ADS1100 only has a fixed 1.25V internal reference voltage, while the ADS1110 has two options, internal reference voltage and external reference voltage, which can be programmed according to needs.3. Resolution: ADS1110 has 16-bit resolution, while ADS1100 only has 12-bit resolution.4. Sample rate: The maximum sampling rate of the ADS1110 is 860 samples/sec, while the maximum sampling rate of the ADS1100 is 128 samples/sec.

Product Features

  • Input: 0-12V
  • Software Development Platform: Arduino, UIFlow(Blockly, Python)
  • ADS1100
    • 16-bits Resolution
    • CONTINUOUS SELF-CALIBRATION
    • SINGLE-CYCLE CONVERSION
    • PROGRAMMABLE GAIN AMPLIFIER GAIN = 1, 2, 4, OR 8
    • LOW NOISE: 4μVp-p
    • PROGRAMMABLE DATA RATE: 8SPS to 128SPS
    • INTERNAL SYSTEM CLOCK
    • I2C INTERFACE: address 0x48

Include

  • 1x ADC HAT V11
  • 1x 2 Pin 3.96 Pitch Terminal

Applications

  • Analog Signal Capture

Specification

Resources Parameter
Net weight 6g
Gross weight 14g
Product Size 24*25*13mm
Package Size 40*42*30mm

EasyLoader

download EasyLoader

1.EasyLoader is a simple and fast program burner. Every product page in EasyLoader provides a product-related case program. It can be burned to the master through simple steps, and a series of function verification can be performed.

  1. After downloading the software, double-click to run the application, connect the M5 device to the computer through the data cable, select the port parameters, click "Burn" to start burning. (For M5StickC burning, please Set the baud rate to 750000 or 115200)

Pin Map

M5StickC GPIO0 GPIO26 5V GND
HAT ADC SDA SCL 5V GND

Schematic

Example

Arduino

UIFlow

Open http://flow.m5stack.com and Load Demo