Module COMX LoRaWAN470 is a LoRaWAN communication module launched by M5Stack, suitable for the 470MHz frequency. The module adopts the ASR6501 solution, supporting long-distance communication while featuring ultra-low power consumption and high sensitivity. The module integrates the LoRaWAN protocol stack and uses a serial communication interface (controlled by AT commands). It can be used as a collection node to connect to gateways in large numbers for data collection and management.
The module provides an external power interface (with a toggle switch to adjust between 5V/12V power input). It is suitable for long-range, low-power IoT communication applications, such as environmental monitoring node deployment.
Note
Compatibility
When used with the Fire controller, due to PSRAM pin conflicts (G16/G17), please switch the module base toggle switch pins to TX(G0/G13) and RX(G5/G15).
Features
ASR6501
Operating frequency: 470MHz
SMA antenna
Command protocol: AT commands
UART communication interface:
Baud rate: 115200
Stop bit: 1
Data bit: 8
Parity bit: None
Terminator: None
Includes
1 x Module COMX LoRaWAN470
1 x SMA antenna
Applications
Automatic remote meter reading
Smart traffic and parking systems
Remote irrigation and environmental monitoring
Specifications
Specification
Parameter
UART Baud Rate
115200
DC Power Port
Input: DC 5–12V, compatible with DC5521 (5.5 × 2.1 mm) plug, center positive
Net Weight
35g
Gross Weight
72g
Product Size
54.2 x 54.2 x 13.2mm
Package Size
165 x 60 x 36mm
Learn
Before Use
Before using this product, please confirm and comply with local radio regulations, and configure the LoRa operating frequency band, transmit power, and other communication parameters appropriately.
CN470 Supported Countries and Regions
China
Power Supply Switching
The module base has a DC power input interface. When using this interface to connect to a power supply, please strictly adhere to the input range (5-12V) to prevent module damage. The internal power toggle switch can adjust the voltage level of the internal VIN terminal to adapt to different modules.
Schematics
Module COMX Baseboard Schematic
PinMap
Adjust the toggle switch to the corresponding pins based on different host requirements.
Controller
CoreS3
Core2
Core
RXD
17/0/7
14/0/19
17/0/13
TXD
18/1/13
13/33/2
16/5/15
M5-Bus
Switch
The pins marked SW on the M5-Bus below can be switched via DIP switches to adapt to different main controllers.