Atomic Stepmotor Base

Example

from m5stack import *
from m5ui import *
from uiflow import *
from easyIO import *
import machine

dir_flag = None
run_flag = None
adc_val = None

def buttonA_wasDoublePress():
  global dir_flag, run_flag, adc_val, adc0, PWM0
  if dir_flag == 0:
    dir_flag = 1
  else:
    dir_flag = 0
  pass
btnA.wasDoublePress(buttonA_wasDoublePress)

def buttonA_wasPressed():
  global dir_flag, run_flag, adc_val, adc0, PWM0
  if run_flag == 0:
    rgb.setColorAll(0x33ff33)
    run_flag = 1
  else:
    rgb.setColorAll(0x000000)
    run_flag = 0
  pass
btnA.wasPressed(buttonA_wasPressed)

digitalWrite(21, 1)
digitalWrite(22, 0)
dir_flag = 0
run_flag = 0
adc0 = machine.ADC(33)
adc0.width(machine.ADC.WIDTH_12BIT)
adc0.atten(machine.ADC.ATTN_11DB)
adc_val = 0
rgb.setColorAll(0x000000)
PWM0 = machine.PWM(19, freq=12000, duty=0, timer=0)
PWM0.pause()
PWM0.duty(50)
while True:
  adc_val = adc0.read()
  if run_flag == 1:
    PWM0.resume()
  else:
    PWM0.pause()
  if dir_flag == 1:
    digitalWrite(23, 1)
  else:
    digitalWrite(23, 0)
  print(adc_val)
  wait_ms(2)
 

API

stepmotor = Stepmotor('Full')
 

• Initializes the stepper motor, setting the stepping mode to full step, which affects the motor’s stepping style and precision.

stepmotor.disable()
 

• Disables the stepper motor, stopping its operation so it will no longer receive movement commands.

stepmotor.enable()
 

• Enables the stepper motor, allowing it to begin executing commands and responding to control signals.

stepmotor.get_status()
 

• Gets the status of the stepper motor, typically used to check whether the motor is enabled or operating normally.

stepmotor.get_voltage()
 

• Retrieves the voltage of the stepper motor, potentially for monitoring power supply conditions to ensure the motor operates within the correct voltage range.

stepmotor.move_circles(0, 0)
 

• Sets the motor to rotate a specified number of circles in a clockwise direction, used to control the motor's rotation angle.

stepmotor.move_steps(0, 0)
 

• Sets the motor to move a specified number of steps in a clockwise direction, allowing precise control over the motor’s rotation angle.

stepmotor.reset()
 

• Resets the stepper motor or a connected device to its initial state.