pdf-icon

Product Guide

Home Assistant

M5CoreS3 Voice Assistant
CM4Stack

IoT Cloud

IoT Tools

LoRa & LoRaWAN

Network

Network Over COM.LTE

Ai Camera

Wi-Fi Camera

Ethernet Camera

Linux

Smart Home

M5AtomEcho

STT
BT Audio

M5Paper

ToDo List

Motor Control

6060 Push

Hobby Kits

Bala
Bala2
Face Kit

Ezdata

Ezdata 2.0 API
Ezdata 1.0 Arduino API

Easyloader

Easyloader Packer

Network Over COM.LTE Tutorial

The Network Over COM.LTE mode allows devices to send all network data via LTE when using UIFlow.

Note: When using the CORE2 in Network Over COM.LTE mode, the 5V power supply for M-BUS will switch to input mode. Therefore, please directly input 5V power to M-BUS or use a DC adapter to connect to the LTE module for power supply.

Preparation

Driver Installation

Before programming, users of M5Core hosts (including BASIC/GRAY/M5GO/FIRE/FACES/CORE2) should click the buttons below to download the corresponding CP210X driver package according to your operating system. After extracting the package, select the installation package corresponding to the operating system bit.

  • Download CP210X Driver

Windows10

MacOS

Linux

Burning Tool

Please click the buttons below according to your operating system to download the corresponding M5Burner firmware burning tool. Extract and open the application.

Software Version Download Link
M5Burner_Windows Download
M5Burner_MacOS Download
M5Burner_Linux Download
Note:
For MacOS users, after installation, please move the application to the Application folder as shown in the image below.
For Linux users, switch to the decompressed file path and run ./M5Burner in the terminal to run the application.

Firmware Burning

  1. Double-click to open the Burner burning tool. Select the corresponding device type from the left menu and choose the firmware version you need. Click the download button to start downloading.
  1. Connect the M5 device to the computer via a Type-C data cable, select the corresponding COM port, and click "Burn" to start burning.
  1. When the burning log prompts Burn Successfully, it means that the firmware has been successfully burned.

LTE Module

  1. Insert the MicroSIM card into the module's card slot, adjust the DIP switch to Enable pin 13,5, and connect the external antenna.

When using a CORE1 device, please adjust the DIP switch to pin 13,5, and for CORE2, adjust the DIP switch to pin 16,17.

Setting APN / Switching Mode

  1. Click Configuration, the software will start reading the current device's configuration information. In the pop-up configuration box, you can reconfigure the APN according to the carrier you are using. (Default APN is CMNET)
  1. Switch the device to COM.LTE working mode. You can set the COM.X option to True in the configuration box or switch the mode after the device starts up by entering the Setup configuration page.

Getting Started

  1. After configuration is complete, the device will automatically start and begin checking. After passing the test, it will enter the programming mode page.
  1. Refer to the following example to get the current IP of the local machine by sending an HTTP request to the URL https://httpbin.org/ip.
On This Page