pdf-icon

ATOMS3 Lite firmware flashing and program pushing

1.Preparation

Refer to the UIFlow Web IDE tutorial , to learn the basic process of using UIFlow 2.0 and complete the installation of the M5Burner firmware burning tool.

  • Log in to register M5Burner, and the device information will be bound to the account at the same time after the device is successfully burned.
  • Download the firmware for 'ATOMS3 Lite' from M5Burner, as shown below.

2.Port selection

Connect the device to the computer via a USB cable, select the Burn button of the corresponding firmware in M5Burner, fill in the WiFi information, and select the corresponding device port.

3.Firmware burning

Connect the device to the computer via a USB cable, select the Burn button of the corresponding firmware in M5Burner, fill in the WiFi information, and select the corresponding device port.

Note: If your device is connecting for the first time, you need to bind the device to this account.

4.Modify the device configuration

Once the firmware is burned, the device will reboot, keeping the USB connection connected. Using the M5Burner Click Options, fill in the device configuration that needs to be modified, and click. Note: If the burning is successful, you need to restart the device, and if you need to change the device configuration again, you need to modify the programming configuration again.Configurenext

5.Log in to UIFlow2.0

Click the user icon in the upper right corner of the page to log in to your UIFlow2.0 system account. Note: The account needs to be the same account as the login, after the account is successfully logged in, under the account, the device connected to the valid WIFI can be viewed by clicking on it, if you need to change the device owner, you need to unbind the relationship between the device and the account.M5BurnerSelect Device

WWI-FI MODE (OFFLINE MODE)

Make sure that WIFI has been configured: When burning the program, you need to configure the WIFI and other information in the M5Burner programming program Configurable.

Select an online device.

USB mode

AtomS3 Lite connects to the USB port of the computer, click the buttonWebTerminal

Select the USB-connected device in the pop-up box, click Select, and when the WebTerminal screen shows Connected to Serial Port! Description The USB connection is successful.

6.RUN

Once you've completed the above steps, you're ready to start programming with UIFlow 2.0.

  • AtomS3 Lite Video tutorial
On This Page