Tab5 Arduino Program Compilation & Upload

1.Preparation

• 1.Arduino IDE Installation: Refer to the Arduino IDE Installation Guide to complete the IDE installation.
• 2.Board Manager Installation: Refer to the Basic Environment Setup Guide to complete the M5Stack board management installation and select the development board M5Tab5。

• 3.Library Installation: Refer to the Library Management Installation Guide to complete the installation of the M5Stack driver library. and download all the dependent libraries according to the prompts.

2.Download Mode

With USB cable or battery connected, long‑press the Reset button (2 seconds) until the internal green LED rapidly blinks; release to enter download mode and await firmware flashing.

3.Port Selection

Connect the device to the computer via a USB cable. After completing the driver installation, select the corresponding device port in the Arduino IDE.

4.Program Compilation & Upload

Open the sample program "BarGraph" in the M5GFX driver library, then click the upload button to automatically compile and flash the program.

The example program runs as follows:

5.Related Resources

• Arduino Library
  • M5Unified
  • M5GFX
• Arduino API & Examples
  • IMU
  • Mic
  • Speaker
  • Touch